Using a micro:bit and a NeoPixel strip, create your custom lighting for dark night bicycle rides.
A laser projector made with 25 dot lasers, a micro:bit board, and Ada programming.
I designed this project for my kids with the idea of combining 3D printing, laser cutting, electronics, coding and a little bit of science.
This is a project I built and showcase here. It represents my virtual Best Wishes for these holidays, to all the community members.
In this article, I am going to talk about sensing light using a photo-resistor sensor and BBC Micro:Bit.
Learn how to connect a Snap Circuits LED to the snap:bit and control it with the micro:bit.
This tutorial is all about working with the light level of micro:bit and to know that the place where you're is dark or brighten.
Micro:Bit Police Red and Blue Flashing LEDs and Siren
Turn any LED from Snap Circuits into a blinking LED. The micro:bit will automatically turn the LED on and off every second.
Learn how to program the micro:bit to turn the Lamp (L1) of Snap Circuits on and off with the help of the NPN Transistor (Q2).
Learn how to turn your micro:bit to a countdown timer that emits light and sound using Snap Circuits components.
Learn how to control the state of the LED with the press switch.
Adding an active NeoPixel lighting system to your E-Bike using the micro:bit.
Learn how to apply special effects on the LED of Snap Circuits with the help of the BBC micro:bit.
Short of batteries? Power your Snap Circuits from the micro:bit!
Turn the LED from Snap Circuits into a Morse code beacon with the help of the BBC micro:bit.
Learn how to change the brightness of the connected Red LED (D1) of Snap Circuits by writing an analog signal to the micro:bit pin.
Add some life to your Halloween decorations! Using micro:bit + LEDs, and some spooky music!
Terms. Site powered by Hackster.io