At the end of this article, you will have complete knowledge of how you can control a mini servo using a BBC micro:bit.

In this quick and easy project, you build a micro:bit moisture sensor

Display screen Showing time and temperature with your micro:bit.

Here, we'll learn how to make a simple arcade game.

Create your own shake controlled weather station with the help of this tutorial in under 5 minutes!

DIY craft propeller anemometer, connected to BBC Micro:bit using Snap:bit and Snap Circuits.

Using the Micro:bit & xCHIPs assembly of this temperature monitor is effortless. Coding is a piece of cake with the blocks of software too!

The Pomodoro technique is a time management method. The technique uses a timer (work for 25 minutes, rest for 5, and so on).

Micro:Bit Police Red and Blue Flashing LEDs and Siren

Learn how to program the micro:bit to turn the DC Motor (M1) of Snap Circuits on and off with the help of the NPN Transistor (Q2).

Learn how to use the infrared receiver (U24) of Snap Circuits to detect input from remote controls with the micro:bit.

Learn how to connect a Snap Circuits LED to the snap:bit and control it with the micro:bit.

Learn how to power the micro:bit from the battery holder of Snap Circuits.

Learn how to turn your micro:bit to a countdown timer that emits light and sound using Snap Circuits components.

Learn how to play sounds and music from the BBC micro:bit through the Whistle Chip (WC) of Snap Circuits.

Build your own pot of gold for St. Patrick's Day from Lego bricks and make it count the coins with the help of Micro:bit and Snap Circuits.

Turn the LED from Snap Circuits into a Morse code beacon with the help of the BBC micro:bit.

Learn how to play sounds and music from the BBC micro:bit through the Speaker of Snap Circuits.

Super simple yet fun humidity project. Easy assembly and programming, you'll be ready to shake in 5 minutes.

Learn how to program the micro:bit to turn the Lamp (L1) of Snap Circuits on and off with the help of the NPN Transistor (Q2).

Blow Game is based on the project "Measure Wind Speed with Micro:bit and Snap Circuits" in which two players try to over blow the other.

Turn any LED from Snap Circuits into a blinking LED. The micro:bit will automatically turn the LED on and off every second.

Learn how to use the photoresistor (RP) of Snap Circuits as a light sensor input for the micro:bit.

Learn how to change the brightness of the connected Red LED (D1) of Snap Circuits by writing an analog signal to the micro:bit pin.